3/4 in. Push-to-Connect x 3/4 in. Female Pipe Thread x 18 in. Braided Stainless Steel Water Heater Connector with BV Item Weight:1.25 Utilizes a 110 mm vent

Utilizes a 110 mm vent pipe (sold separately) but with an outdoor installation no vent is needed

1/2 wave VHF and 5/8 over 5/8 wave UHF

Feet) 187 Commercial/Residential Commercial/Residential Color/Finish Family Black Scratch Resistant No Stain Resistant Yes Salt Resistant Yes Warranty Limited lifetime Protective Urethane Layer No Protective Aluminum Oxide Layer No Sold As Roll CA Residents: Prop 65 Warning(s) Yes Type Roll Finish Pattern Design Leather Size 8-1/2-ft x 22-ft Textured Yes Thickness Measurement 55-mil Installation Type Locking/Floating

06 in Number of Faucets Holes 2 Spout Height (in

3/4 in. Push-to-Connect x 3/4 in. Female Pipe Thread x 18 in. Braided Stainless Steel Water Heater Connector with BV Item Weight:1.25 Utilizes a 110 mm ventThe 3 4 in. x 18 in. Tectite by Apollo Water Heater Connector with Factory Integrated Ball Valve was designed for the fast and simple installation of hot and cold water lines to water heaters. After applying pipe thread tape to the MNPT nipples on your water heater, thread the FNPT end of the Water Heater connector onto the tank and tighten with pliers. Then simply push the Tectite by Apollo Push To Connect end onto Copper, PEX, or CPVC pipes and your